The FRP bracket system manufacturer tells you that the installation should be horizontal, and if it is tilted, additional steps are required to repair the cable. The balance, vertical and horizontal spacing of the brackets on the same side is 80 cm, and the brackets on both sides are staggered to ensure the balanced bearings of the brackets. The bracket should ensure that the bracket support and the concrete are engaged and dense, and maintain a right angle with the fixed wall to ensure the bearing area of ​​the base and avoid deformation. When laying cables, it is advisable to use top-down laying, and drag the cable horizontally to drag the FRP bracket system. Pay attention to the advantages of the FRP bracket system in the use of power.

Everyone said that the wind power companies have been in a bad situation in the past two years, their profits have plummeted, and their growth has slowed down. However, as far as I know, the State Council and the Electric Power Administration have not changed the development strategy of wind power, but have given support from the beginning, and the approval progress of wind power projects is also accelerating.
According to the research results, it is believed that by 2020, 2030 and 2050, the FRP bracket system manufacturers will tell you that my country's wind power facilities will reach 200 million kilowatts, 400 million kilowatts and 1 billion kilowatts, and wind power will account for 17% of the total power generation. Become the top five power sources and become a useful alternative energy source.
The problem of grid acceptance is not a technical problem. FRP bracket system manufacturers tell you that many people believe that there is electricity when there is wind, and there is no electricity when there is no wind, which has a great impact on the power grid. I didn't use the word on and off. Many newspapers and media think wind is intermittent, but I think wind is fluctuating. As far as the grid is concerned, the current capacity base is not a very difficult problem. Research reports at home and abroad have proved this. The FRP bracket system manufacturer tells you that when the proportion of wind power in the power grid is less than 20%, the existing technology and management can handle it without increasing the economy and cost.